Valve Cover Gasket – Kinner K-5 engine “ULTIMATE” Silicone

$8.00

SKU:RG-K5FR

VALVE COVER GASKETS “ULTIMATE” SILICONE 

for

KINNER K5 Engines

 

ULTIMATE” SILICONE IS FIBERGLASS REINFORCED SILICONE.

 

This may be the last gasket you will ever need to buy!

 

   Basically “Ultimate” silicone is a layer of fiberglass

     centered between 2 layers of silicone.

     This gives the material dimensional stability and

      higher tensile strength. 

–   Tensile strength is the absolute most stress that a

     material can resist while being pulled or stretched, as

     a result this is one tough gasket.

–   The gaskets are made from aerospace mechanical grade 

     silicone and will not break down and deform or crack up 

     like cork or neoprene.   

–   Additionally this material is resistant to deterioration by

     weathering and engine oil and remains flexible over the

     temperature range from -100 to 500 degrees F.      

–   Best of all, it is a reusable gasket.

 

FITS:      Kinner K-5 Engine

  

PART #:   RG-K5FR

This is a 2 bolt hole SILICONE GASKET

Price is per gasket.

Gaskets are 1/8″ thick fiberglass reinforced silicone.

Reusable gaskets.

 

INSTALLATION INSTRUCTIONS:

  1.    Wash the cover and cylinder head surfaces with solvent.  
  2.    Remove all traces of oil.
  3.    Gasket surfaces must be clean and dry.
  4.    Silicone gaskets are installed DRY (No oil or lube used of any type).
  5.    TORQUE:    45 TO 50 INCH POUNDS.  

   

CAUTION – DO NOT OVER-TIGHTEN!

If the gasket starts to bulge out or “pooch” or squish out when torqueing

– then you are over tightening the bolts.  

Back off on the torque.

 

TO REUSE GASKET: 

  1.    Wash the gasket in hot soapy water.  
  2.    Rinse well and dry all surfaces thoroughly.   
  3.    Then re-install using the above installation instructions.

 

Proudly made in the USA.

CONTACT US

Real Gaskets Tennessee
2120 West G Street
Elizabethton, TN 37643 U.S.A.

1 (800) 635-7325

1 (423) 543-6194