Valve Cover Gasket Set – Porsche 911 – 914 – 930 engines; black silicone

VALVE COVER GASKET SET – BLACK Silicone

fits

PORSCHE  911 – 914 – 930

– 4  piece set

– 11 Bolt Hole Lower Exhaust Gasket 

– 6  Bolt Hole Upper Intake Gasket

–   Our silicone rubber gaskets are made from aerospace mechanical

     grade AMS  silicone and designed to withstand temperatures up to

     400 degrees Fahrenheit.   

–   Therefore, they will not break down and deform or crack up like

      cork or neoprene.   

–   Our gaskets seal uneven and warped surfaces and 

      eliminate corrosion.

–    Gaskets are 100% reusable.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

FITS:     Porsche 

              911-914-930 Engines

                – 1967 1/2  to  1989

              Porsche 

             Turbo 911 Engines

                – 1976  to  1992

PART #:  RG-911-LATE-4B 

Corresponding part #:

930 105 195 01 98; 930 105 195 02

SET OF 4 GASKETS 

–  Two Upper intake gaskets     – 6 bolt holes  

–  Two Lower exhaust gaskets – 11 bolt holes

–  Hardware not included

It is recommended that the Nylock nuts and aluminum washers be replaced each time

the valve covers are removed, but that applies to any valve cover gasket.

–   Gaskets are 1/16″ thick BLACK silicone.

–   Reusable.

Follow the torque instructions on the label.   

These gaskets use a light torque.

INSTALLATION INSTRUCTIONS:

• Wash the cover and cylinder head surfaces with solvent.    
• Remove all traces of oil.
• The gasket must be installed DRY – (no oil or lube of any type).
• Torque:   15  INCH Pounds    DO NOT OVER TIGHTEN!
•                 2.7 – 3.6    kg-cm 
•             1.7 – 2.6   N’m
• DO NOT let the gasket bulge or squeeze out.  
• This is a sign of overtightening

TO REUSE THIS GASKET: 

Wash gaskets briefly in hot soapy water.  

Rinse well and dry all surfaces thoroughly.  

Re-install using above installation instructions.

We also sell these gaskets in orange silicone.  Part # RG-911-Late-4

PROUDLY MADE IN THE USA.