VALVE COVER GASKETS – SILICONE

for

PRATT & WHITNEY  R-985 Series

–   Our silicone rubber gaskets are made from aerospace mechanical

     grade AMS  silicone and designed to withstand temperatures up to

     400 degrees Fahrenheit.   

–   Therefore, they will not break down and deform or crack up like

     cork or neoprene. 

–   Our gaskets seal uneven and warped surfaces and 

     eliminate corrosion.

–   Gaskets are 100% reusable.

FITS:        Pratt & Whitney

                 R-985 SERIES WASP JR   

            (4 HOLE GASKET)

             FAA-PMA approved

PART #:   RG-90560

Gaskets are 1/16″ thick silicone

Gasket sold individually

A complete set is 18 gaskets.

Reusable.

Also available in packages of 18 gaskets.  See RG-90560-18

INSTALLATION INSTRUCTIONS:

1.    Clean valve covers with solvent and remove all traces of oil.
2.    Gasket surfaces must be clean and DRY.
3.    Install gaskets DRY.       
4.    TORQUE: 10 TO 14 INCH POUNDS.      

CAUTION – DO NOT OVER-TIGHTEN!

Over tightening makes the gaskets bulge out or squeeze out.  

If that happens then back off on the torque.

Instructions are included in the package of gaskets.

TO REUSE GASKETS: 

1.    Wash gaskets briefly on hot soapy water. 
2.    Rinse gasket thoroughly and then dry all surfaces. 
3.    Re-install gaskets following the above installation instructions.

Proudly made in the USA.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~