VALVE COVER GASKET  –  SILICONE

for

Moto Guzzi  –  Round Fin Big Twin

–   Our silicone rubber gaskets are made from aerospace mechanical

     grade AMS silicone and designed to withstand temperatures

     up to 400 degrees Fahrenheit.   

–   Therefore, they will not break down and deform or crack up

     like cork or neoprene.   

–   Our gaskets seal uneven and warped surfaces, and

     eliminate corrosion.

–   Gaskets are 100% reusable.

Fits:       Moto Guzzi  Round Fin Big Twin  

              1967-1984:

Models:     

V700, Ambassador;  Eldorado;  V7 Special, V7 Sport,

750 Sport,  750S, S3, 850 GT;

V850, 850T, 850-T3, T4; Convert,

850 LeMans, LeMans II, CX100, G5, SP1000

Part #:           RG-12023700

Corresponding part #:  MG-1;  OEM #12023700

Set of 2 silicone gaskets –  1/16″  thick

Reusable

INSTALLATION INSTRUCTIONS:

1.    Wash the cover and engine flange with solvent. 
2.    Remove all traces of oil.
3.    The surfaces must be DRY  (No oil or lube of any type).
4.    Use LOCK WASHERS or THREAD LOCK
5.    TORQUE (one time):   15 INCH pounds   

 DO NOT OVER TIGHTEN!

Over tightening makes the gasket bulge out or squeeze out.

If that happens then back off on the torque.

These instructions come with the gasket.

TO RE-USE GASKET:

1.    Wash gasket in hot soapy water.   
2.    Rinse well and dry thoroughly.
3.    Re-install gasket using the above installation instructions.

Proudly made in the USA.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~