Valve and Side Cover Gaskets – MG for MGA and MGB

VALVE COVER GASKET 

and 

SIDE COVER GASKETS – SILICONE

for

MG MGB

–   Our silicone rubber gaskets are made from aerospace mechanical 

     grade AMS silicone and designed to withstand temperatures 

     up to 400 degrees Fahrenheit.   

–   Therefore, they will not break down and deform or crack up 

     like cork or neoprene.  

–   Our gaskets seal uneven and warped surfaces,

    and eliminate corrosion.

–   Gaskets are 100% reusable.

FITS:               Late Model MGA 1500/1600

            and MGB 1800 Engines 

            361, 383, 400, 413, 440 CID

Part #:    MGB-1

SET OF THREE (3) SILICONE GASKETS:

– GASKET THICKNESS IS 1/4″ SILICONE.

– One valve cover gasket and two side cover gaskets

    Outer dimensions of each gasket:

    Valve cover gasket:  15 inches in length and 4 3/4 ” in width.

    Side cover gaskets:  6 1/4″ in length x 3″ in width

Please check your side covers to be sure these would fit.

(Apparently there are two different sizes of side covers.)

Reusable silicone gaskets.

INSTALLATION  INSTRUCTIONS:    

Wash the cover amd cylinder head surfaces with solvent. 

Remove all traces of oil.   

The gaskets must be intsalled DRY   (NO OIL  OR LUBE OF ANY  TYPE).

TORQUE TO 20-25 INCH POUNDS 

DO NOT OVERTIGHTEN!    

It causes the gasket to bulge or squeeze out.

Directions are included on the package label.

 TO REUSE GASKET:   

Wash gasket briefly in hot soapy water.

Rinse gasket and dry thoroughly.

Re-install using the above installation instructions.

DO NOT SOAK  GASKETS IN SOLVENT OR GASOLINE. 

Proudly made in the USA.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~