VALVE COVER GASKET – SILICONE

for 

CHRYSLER, DODGE, PLYMOUTH

MOPAR SLANT 6  –  170,198, 225 CID  

–   Our silicone rubber gaskets are made from aerospace mechanical 

     grade AMS silicone and designed to withstand temperatures 

     up to 400 degrees Fahrenheit.   

–   Therefore, they will not break down and deform or crack up 

     like cork or neoprene.   

–   Our gaskets seal uneven and warped surfaces,

     and eliminate corrosion.

–   Gaskets are 100% reusable.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

FITS:  CHRYSLER, DODGE & PLYMOUTH

            SLANT 6,   170 – 198 – 225 CID 

         1960 – 1980

Part number:  RG-12680  

Corresponding part #’s: FelPro VS12680R; Detroit Gasket 19021; 

Victor VS39745;  McCord CV1023CE  and  MVC-3

One (1) silicone gasket 

Gasket is 1/8″ thick and has eight (8) bolt holes.

Reusable.

In addition, this gasket is made in “ULTIMATE” fiberglass reinforced silicone

– Part # RG-12680FR

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

INSTALLATION INSTRUCTIONS:

1.    Wash the cover and cylinder head surfaces with solvent.   
2.    Remove all traces of oil.
3.    The gasket MUST be installed DRY (No oil or lube of any type).

            TORQUE to 20-25 INCH POUNDS  

DO NOT OVER TIGHTEN. 

If the gasket starts to bulge out then you are over tightening 

and should back off on the torque.

To reuse gasket: 

1.    Wash the gasket briefly in hot soapy water.
   
2.    Rinse gasket and dry thoroughly.
3.    Re-install gasket using the above installation instructions.

PROUDLY MADE IN THE USA. 

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~