Valve Cover Gaskets – Chevrolet – Small Block V/8 – “ULTIMATE” Silicone

$49.00

SKU:RG-12869FR

VALVE COVER GASKETS

               for

CHEVROLET –  SMALL BLOCK V/8

 

**ATTENTION:  If you are using thin steel valve covers, do not use this fiberglass reinforced gasket.  Use the silicone gasket RG-12869 instead.**

Made of:

ULTIMATE”  SILICONE, 

A FIBERGLASS REINFORCED SILICONE 

 

This may be the last gasket you will ever need to buy! 

  

–   Basically, the gaskets have a layer of fiberglass that is centered

    between 2 layers of silicone which allows the material to

    maintains its original dimensions when subjected to changes in

    temperature and humidity.   

 

    As a result, it gives the material dimensional stability and

    has a higher tensile strength.      

    This is the absolute most stress that a material can resist while

     being pulled or stretched. 

 

–    Not only is the material resistant to deterioration by weathering

     and engine oil but also withstands temperatures and remains

     flexible over the temperature range of  -100 to 500 degrees F.

  

–    Additionally, the gaskets are made from aerospace mechanical 

     grade silicone and will not break down and deform or crack up

     like cork or neopreneConsequently, this is one tough gasket. 

 

  –   Finally, this is a reusable gasket

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Valve Cover gasket set for    

CHEVROLET  –   SMALL BLOCK V/8

262, 265, 283, 302, 307, 327, 350, 400 CID.

Years:    1957 to 1987

 

Part number:       RG-12869FR

Corresponding part #’s:  FelPro VS12869R,  CVC-1FR

SET OF 2 “ULTIMATE” Silicone GASKETS.     

Gaskets have six (6) bolt holes and are 1/8″ thick.   

Re-usable. 

 

In addition, this set of gaskets is also made out of plain silicone

See part #:  RG-12869

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

INSTALLATION INSTRUCTIONS: 

  1.    Wash the cover and cylinder head surfaces with solvent.    
  2.    Remove all traces of oil.
  3.    The gasket must be installed DRY   (No oil or lube used of any type).

                   TORQUE TO:   45-50 INCH POUNDS.   

 

                       Do not overtighten  

                     –  over tightening makes the gasket bulge or squeeze out.

 

TO REUSE GASKET:  

  1.    Wash gasket in hot water and soap.   
  2.    Rinse well and dry all surfaces thoroughly.  
  3.    Re-install using the above installation instructions.  

 

PROUDLY MADE IN THE USA.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

CONTACT US

Real Gaskets Tennessee
2120 West G Street
Elizabethton, TN 37643 U.S.A.

1 (800) 635-7325

1 (423) 543-6194