Valve Cover Gaskets – Chrysler, Dodge, Plymouth – Small Block V8 “ULTIMATE” Silicone Gasket

VALVE COVER GASKETS  – 

   “ULTIMATE” SILICONE

                           for

MOPAR SMALL BLOCK V8

**ATTENTION: If you are using thin steel valve covers, do not use this fiberglass reinforced gasket. Use the silicone gasket RG-1607 instead.**

This may be the last gasket you will ever need to buy!

  –    Basically, the gaskets have a layer of fiberglass that is centered

        between 2 layers of silicone which allows the material to

        maintains its original dimensions when subjected to changes in

        temperature and humidity.   

        As a result, it gives the material dimensional stability and

        has a higher tensile strength. 

       This is the absolute most stress that a material can resist while

        being pulled or stretched. 

  –    Not only is the material resistant to deterioration by weathering

        and engine oil but also withstands temperatures and remains

        flexible over the temperature range of  -100 to 500 degrees

        Fahrenheit. 

–     Additionally, the gaskets are made from aerospace mechanical  

        grade silicone and will not break down and deform or crack up

        like cork or neoprene.    

         Consequently, this is one tough gasket. 

  –   Finally, this is a reusable gasket.

Fits Models:

Chrysler, Dodge, Plymouth – Small Block V8 

1966-1990

 273, 318, 340, 360 CID

Part number:  RG-1607FR

Corresponding part #’s: 

SFL1607; SFL VS 13395; Moroso 93050; SFL1608; 

P4452089; MVC-1FR   

Set of two silicone gaskets – 1/8″ thick

Gaskets have five bolt holes

Reusable.

Also, this gasket is available in regular silicone under part # RG-1607

INSTALLATION INSTRUCTIONS:

1. Wash the cover and cylinder head surfaces with solvent.   
2. Remove all traces of oil.
   
3. The gasket MUST be installed DRY (No oil or lube of any type).
4. TORQUE to 45-50 INCH POUNDS    

         DO NOT OVER TIGHTEN.

         Over tightening causes the gasket to bulge out or 

         squeeze out.

***   ***   ***   ***   ***   ***   ***   ***   ***   ***   ***   ***   ***   ***   

To reuse gasket: 

1. Wash the gasket briefly in hot soapy water.   
2. Rinse well.   Dry all surfaces thoroughly.
   
3. Reinstall using the above installation instructions.

Proudly made in the USA.

 ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~