Valve Cover Gaskets – Chrysler Big Block 426 Hemi V8 – “ULTIMATE” Silicone

VALVE COVER GASKET SET – “ULTIMATE” Silicone

                  for

          CHRYSLER 426 HEMI V8

“ULTIMATE”  SILICONE IS FIBERGLASS REINFORCED SILICONE. 

This may be the last gasket you will ever need to buy!

• A layer of fiberglass is centered between 2 layers of silicone

          and gives the material extra stability and ultimate strength.

          This is the absolute most stress that a material can resist

          while being pulled or stretched which makes this

          one tough gasket. 

• The material is resistant to deterioration by weathering and

          engine oil and remains flexible over the temperature range

          and withstands temperatures from -100  to 500 degrees F.

• The gaskets are made from aerospace mechanical grade

          silicone and  will not break down and deform or crack up

          like cork or neoprene.            

• This is a reusable gasket.

Fits Models:        CHYRSLER 426 Hemi V8 –  Big Block  –  1966-1971

                                   1967-1971      7.0L 426CI V8   OHV VIN R  

                            1967-1970      7.0L 426CI V8   OHV VIN J   

                            1966               7.0L 426CI V8   OHV VIN H  

Part #:                RG-426FR 

Corresponding part #: Fel Pro VS50007 C, P4120353; SFL1657; Mr Gasket 374, 380

Set of 2 “Ultimate” Silicone gaskets

– 1/8″ thick

– 10 bolt holes in gasket

Reusable.

INSTALLATION INSTRUCTIONS:

Wash the cover and cylinder head surfaces with solvent.   

Remove all traces of oil.

The gasket MUST be installed DRY (No oil or lube of any type).  

TORQUE to 45 – 50 INCH POUNDS    

DO NOT OVER TIGHTEN.

If the gaskets start to bulge or “pooch” out

–  then you are over tightening.

TO REUSE GASKET:

Wash the gasket briefly in hot soapy water.  

Rinse well.  Dry thoroughly. 

Reinstall using the above installation instructions.

PROUDLY MADE IN THE USA.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~