Valve Cover Gasket Set – Porsche 911 – 914 – 930 engines; black silicone

$61.00

SKU:RG-911-LATE-4B

VALVE COVER GASKET SET – BLACK Silicone

fits

PORSCHE 911 – 914 – 930

– 4 piece set

– 11 Bolt Hole Lower Exhaust Gasket (2 gaskets)

– 6 Bolt Hole Upper Intake Gasket (2 gaskets)

– Our silicone rubber gaskets are made from aerospace mechanical

grade AMS silicone and designed to withstand temperatures up to

400 degrees Fahrenheit.

– Therefore, they will not break down and deform or crack up like

cork or neoprene.

– Our gaskets seal uneven and warped surfaces and

eliminate corrosion.

– Gaskets are 100% reusable.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

FITS: Porsche

911-914-930 Engines

– 1967 1/2 to 1989

Porsche

Turbo 911 Engines

– 1976 to 1992

PART #: RG-911-LATE-4B

Corresponding part #:

930 105 195 01 98; 930 105 195 02

SET OF 4 GASKETS

– Two Upper intake gaskets – 6 bolt holes

– Two Lower exhaust gaskets – 11 bolt holes

– Hardware not included

It is recommended that the Nylock nuts and aluminum washers be replaced each time

the valve covers are removed, but that applies to any valve cover gasket.

– Gaskets are 1/16″ thick BLACK silicone.

– Reusable.

Follow the torque instructions on the label.

These gaskets use a light torque.

INSTALLATION INSTRUCTIONS:

Wash the cover and cylinder head surfaces with solvent.
Remove all traces of oil.
The gasket must be installed DRY – (no oil or lube of any type).
Torque: 15 INCH Pounds DO NOT OVER TIGHTEN!
2.7 – 3.6 kg-cm
1.7 – 2.6 N’m
DO NOT let the gasket bulge or squeeze out.
This is a sign of overtightening

TO REUSE THIS GASKET:

Wash gaskets briefly in hot soapy water.

Rinse well and dry all surfaces thoroughly.

Re-install using above installation instructions.

We also sell these gaskets in orange silicone. Part # RG-911-Late-4

PROUDLY MADE IN THE USA.

Browse